SWS (Seneye Web Server) Instructions (English)

Set Up Steps 

1) Take your slide out of the packaging and soak slide in the water you are going to monitor for 24 hours for freshwater tanks and 48 hours for saltwater tanks.

DO NOT SOAK YOUR SLIDE IN TAP WATER OR RO WATER

2) Set up your Seneye Web Server (SWS) 

3) Connect your Seneye USB Device (SUD) 

4) Insert and activate slide. Detailed instructions: Insert and Activate Slide

DO NOT CONNECT THE SWS TO THE WI-FI ADAPTOR UNTIL INSTRUCTED

Stage 1 - Click here to create a seneye.me account

Once you have created your account, please return to this page to continue setup. 

Stage 2 - Click here to register your Seneye Web Server

PIN and ID on the sticker on the SWS packaging. An EXAMPLE of this is shown below:

Stage 3 - Connecting the SWS to your router

If you are using any products such as BT Parental Controls or SKY shield or other internet security services then the SWS may not be able to communicate with the seneye servers. Please click here for more information.

PLEASE DO NOT CONNECT YOUR Seneye USB Device (SUD) TO THE SWS YET

A.       CONNECT YOUR SWS TO YOUR ROUTER VIA AN ETHERNET (You must do this before you connect your SWS to a wifi module)

1.      Plug the Ethernet cable (supplied) into the purple port on your SWS

2.      Then connect the other end of the cable directly to your router.

B.       CONNECT POWER

1.      Plug the USB power adaptor (supplied) into the mains.

2.      Connect one end of the micro USB cable (supplied) into USB power adaptor.

3.      Connect the other end into the micro USB port (black port) of the SWS.

Your SWS will now boot up:

When your SWS boots, the lights on the front will flash in the following sequence:

Stage 4 - Finding the SWS GUI (Graphic User Interface)

Open a web browser on a device that is on the same area network as your router, if you are running dual-band Wi-Fi you will need to be on the same band. If connecting on a mobile/cell phone, please ensure you have mobile/cellular data turned off.

Your URL was provided when you registered your SWS. It is made up of your ID an example is given below to show the format:

http://2mop534r4o6l.sws.li/

Find your SWS ID on the label on the front of the SWS. If you don't have this label anymore then it can be found by unclipping the back cover of the SWS.

This is what your SWS GUI will look like, don't forget to bookmark it in your browser so you can access it easily!

For more information on how to use your GUI follow this link: Seneye Web Server Graphic User Interface

If you cannot find your SWS GUI, then please contact us at [email protected]

Stage 5 - Connecting your Seneye USB Device

Connect your Seneye USB Device (SUD) directly to the SWS. 

Do not use any form of extension leads as the SUD will not communicate correctly.

Please make sure you keep your SWS in a dry place, away from water and humidity. If you are unable to do this, please purchase our DRI box.