Wi-Fi Module (TP-Link TL-WR802N) Set Up Instructions
Table of contents
[MISSING: System.API.no-headers]Set up Instructions
Power On
Plug the Micro USB power cable into the tp-link's power port. Make sure you are using a standard 5V/1A power adapter. Otherwise, it may malfunction.
DO NOT PLUG IN THE ETHERNET CABLE UNTIL DIRECTED
Connect
Once the TP-Link is powered you will need to go to your network settings from smartphone, tablet, or PC this will then show you the TP-Link
Please ensure you turn off auto-join to your home Wi-Fi network in your wifi setting on your phone, tablet, or PC.
If you are using a smartphone or tablet fully TURN OFF any mobile data access.
A password may need to be entered which can be found at the bottom of the TP-link under (Wireless password pin)
Select the TP-Link through the network settings, once connected open your browser(we recommend Chrome, Firefox) and go to - http://tplinkwifi.net
Access the Web Admin Panel
Admin Password Setting
There is no default password for this Admin Panel.
You must set your password, which must be at least 5 characters long. Then, click Submit to proceed.
After a password has been created you will then be required to click ‘’Next’’
-
Go to the Internet section of the admin panel
-
-
Operation mode – Click ‘Client’ and then Next
-
AP List –Choose your network, fill in the password and click Next
-
Once Connected, make sure DHCP Server is enabled and LAN Type is - Smart IP (DHCP) And click Next
5. Finish setting up GL iNet
Review Setting – To finish the settings setup, click Finish and this will reboot the system.
Once rebooted,if you refresh the page you will get the 'Device not connected to the internet message' You can now plug the Ethernet cable into the SWS and your good to go!
Reset Instructions
If you change your network provide and receive a new router, or change your network password, after you have set up your module, you will need to reset your TP-Link
To reset the module to its factory settings press and hold down the reset button (which is located next to the power port) for 10 - 15 seconds then release. All user data will be cleared.
Please then wait 3 - 5 minutes.
Once the TP-Link has been reset, its light will flash, and it will appear in your network settings. (Follow the set-up instructions from stage 2.)