Edimax Wi-Fi Instructions

    Version as of 08:38, 4 Dec 2024

    to this version.

    Return to Version archive.

    View current version

    seneye recommend the following two modules for use with the seneye web server in order to connect to your router if it is too far away to connect directly.

    If you have a pond or aquarium a long way from your router, but on the same power circuit, an Ethernet over power adaptor may be better than Wi-Fi.

    Wi-Fi

    Recommended product:

    Edimax N300 Universal Wi-Fi Extender 

    L.E.D. light modes

    edimax wifi plug.PNG

    edimax wifi led table 1.PNG

    edimax wifi led table 2.PNG

    Setup instruction

    The set of instructions below is our version to get you up and running as fast as possible.

    You do not need the CD to get the Edimax running and set up.

    Do not connect anything to the Edimax Ethernet port during setup it will prevent the final step of set up.

    The easiest way is to plug the Edimax in to a power socket with nothing attached to its Ethernet port.

    If you have tried to set anything up I would recommend resetting the Edimax to factory setup.

    To reset the Edimax press the WPS and hold it for over 15 seconds until all the lights have changed.

    When the lights change you should then see a new wireless network called Edimax from your phone or PC under wifi connections (if not ‘scan’ for available Wi-Fi networks) . If you don’t see the connection straight away leave it a few minutes to fully boot. If after 5 minutes or longer you don’t see it and it has its power lights on try a reset as described above.

    Attach to the Edimax Wi-Fi connection to your phone or PC by selecting the “EdimaxEXT.Setup XX”

    When you have selected the Edimax connection it should show up as connected on your phone.

    Launch your web browser and type "edimaxext.setup/" into the address bar (not search bar).

    Then press the get started button shown in blue.

     

    Next select the mode of set up we recommend the middle one (bridge).

     

    Next select the Wi-Fi router you want to connect to, you can also see signal strength on the router you are connecting to.

     

    The next step is to enter the password for your Wi-Fi network. Remember the password will be case sensitive.

    Then click next.

    A connection test in now performed.

    If you get the password wrong you will get this screen - DO NOT APPLY IT - go back and enter the password again.

    If the set up is successful it will look like below and have a green tick. You can then press apply.

    If you see the screen below you have set up your Edimax router. The Edimax Wi-Fi will now disappear off your devices Wi-Fi list.

    Connect back to your normal Wi-Fi network.

     

     

    Now you can disconnect the seneye web server from your router and connect it to up to the Edimax as shown in the bottom of the two images.

    SWS wi-fi and ethernet wiring diagram.png

    The full user manual for the E

    dimax EW-7438RPn V2 is available here.

    Ethernet Over Power (E.O.P.)

    Recommended product (click to buy UK plug out):

    Edimax - Ethernet Over Power Pro kit

    Edimax - Ethernet Over Power Starter Kit

     

    Edimax HP-5102ACK

    L.E.D. light modes

     

    edimax eop plug.PNG

    edimax eop led table 1.PNG

     

    The full user manual for the Edimax HP-5102ACK is available here.