Using the reef light meter
Table of contents
Why it is important
The light output levels for your aquarium are very different depending on location. You can move your seneye device around the aquarium to find out the amount of light at any given point. Seneye Reef adds quality and quantity light measurements.
The seneye device and seneye web server or seneye connect software allow you to place corals and plants that have a high light dependency in the best location based on the light output. The round clear window on the black back of the seneye device is used to collect aquarium light information. Understanding light is also important when trying to solve algae problems.
How it works
If you are using the seneye connected to a SWS then please click here for instructions
If you are using the seneye connected to a PC then please click here for instructions.
The seneye light meter is located in the round window on the back of the seneye device. The light levels will change depending on the position of the sensor relative to the light source. For example, if left in the top corner the light readings will be very low and not representative of the light received by corals and plants in different areas..
A seneye reef device provides constant light monitoring and the following measurements; PAR, LUX, Kelvin and Spectra.
The seneye is not fitted with a cosine corrector to cut down on light noise and only report what it is looking at. For this reason, it is important that you position the seneye light meter where you want to take readings and that it is facing the light source.
The device is designed to average light readings so it is important to keep the device in the same position and still while taking readings. Some LED lights use PWM (Pulse Width Modulation) to dim, this can cause readings to move about even though your eye cannot see it.
For more information on light click here.
If you are using the seneye connected to a SWS then please click here for instructions
If you are using the seneye connected to a PC then please click here for instructions.
Please bear in mind the seneye is intended for continual use. If you are only using the seneye to read light levels every now and again, please ensure you take the following care precautions:
1. Ensure the device is connected to the SCA once every 30 days even when not in use for AT LEAST 8 consecutive hours.
2. Keep the seneye stored in a clean and dry place when not in use