Table of contents
2. Connecting your Leak Detector
After you have confirmed that your SWS's firmware has been upgraded, it's time to connect your Leak Detector. To do this, please disconnect your SWS from its power source and then remove the back by pressing in the clips on either side:
With the back off your SWS, connect your Leak Detector's cable to either the port marked 'C' or marked 'D', these are the only ports with which the Leak Detector will work. Don't forget that you can unscrew the white bracket in the centre of the SWS to keep the Leak Detector lead more secure. Once your Leak Detector is connected to your SWS, you can then replace the back of your Web Server.