seneye product network requirements

    Version as of 09:27, 22 Dec 2024

    to this version.

    Return to Version archive.

    View current version

    seneye web server seneye & Sensor Node

    network and Internet requirements

     

    seneye products run on standard Ethernet, WiFi and Internet network protocols.

    If you are using the products with a “normal” home internet connection then you will not need to worry about the following information.

    If your network is in any way managed, has firewalls and restricted access then you may need to adjust your settings or add rules to allow communication.

     

    Seneye Web Server (SWS) & Seneye Sensor Node connection requirements

    Local Area Network connection

    A local IP address is required for each SWS/Node on the network.

    This can be granted with DHCP or Static port from the router.

    The Local IP address can be fixed internally in the SWS/Node on the GUI of the SWS.

     

     

    WAN connection

    The SWS/Node will check for an internet connection (WAN access) and connection to the seneye cloud

    Telemetry is uploaded to the seneye cloud by UDP on port 26517

    Readings are uploaded using HTTPS/HTTP on port 80/port 443

    NTP protocol is used to sync the time and date. UDP/port123

     

     

    UPNP

    If UPNP is enabled on the router the SWS/Node will request a port from the router for two way communications.

    If a port is granted this allows for instantaneous synchronisation between changes on the cloud and the seneye device.

    If UPNP is not available then the SWS/Node will sync with the servers periodically.

    External ports can be manually configured on the GUI of the SWS

     

     

    Seneye sensor node only

    48 volt POE input complying with IEEE_802.3 is required to power the Node.

    MAC addresses for each node can be provided upon request