Belkin Home base web interface

    Table of contents
    1. 1. Discontinued

    Version as of 09:01, 22 Dec 2024

    to this version.

    Return to Version archive.

    View current version

    Discontinued

    The Belkin Home Base has a browser based interface that allows you to adjust more of the settings. To access this, please make sure that you have setup your Belkin correctly on your network and have connected your seneye.

    Disabling the network area storage (NAS) seems to make the connection between the seneye and the Belkin more reliable. The following instructions explain how to open the browser based interface and turn off the NAS settings.

    Find the Local IP address that has been allocated to the Belkin on your network.

    This is done by clicking 'properties' on the Belkin Home Base control Center Software whist the seneye is active.

    Belkin Home base device properties.pngCopy the IP address from into your browser

    Do not include any www's or HTTP on the browser

    This will then open the interface shown below. You then need to click on USB port mode. This will then ask your for a password. By default, the password is blank, so just click 'log in'

    Belkin Home base USB port settings.png

    Untick all of the 'Enable NAS' boxes and click save. 

    This has now disabled NAS from your Belkin