Table of contents
    [MISSING: System.API.no-headers]

    Version as of 09:00, 12 Aug 2020

    to this version.

    Return to Version archive.

    View current version

    pH is a measurement that shows the ratio of +/- hydrogen ions in concentration and is commonly used in the analysis of soil and water testing.  The concept of pH was first introduced by Soren Sorensen in 1909 and revised to the modern pH scale in 1924 which is measured on a scale of 0 to 14 shown below.

    ph scale.png

    In general terms pH of 7 is neutral, pH less than 7 is acidic, and pH greater than 7 is basic, therefore battery acid is more acidic than ammonia and baking soda is more basic than wine. The modern pH scale is logarithmic, which means that a unit decrease in pH is equal to a ten-fold increase in acidity e.g. rain (approx. pH 6) is at least ten times more acidic than distilled water (approx. pH 7).  

    Fish will live in a wide range of pH’s but are slow to adapt, most will live very happily at a wide range of pH’s. Sudden Change in pH can be very dangerous to Fish, plants, bacteria and other living creatures. A seneye device is an excellent way to get alerted to sudden change in the aquarium.

    ph scale for fish keeping.png

    As a rule of thumb pH change in the aquarium should be minimised and anything above pH of 0.5 per day is counted as deadly or bad. Often aquarists changing water chemistry to reach absolute perfect values will cause more harm than good. If the fish are happy then a controlled and constant pH is most important. It is not uncommon to measure a big change when any pH device is recalibrated or new reagents are used; this does not mean the water has changed.

    Daily swings in pH are common in the aquarium; the size of the swing is usually controlled by the hardness of the water (KH). This means marine systems will see very small swings as they have high buffer capacities (KH), however soft freshwater aquariums (especially Amazonian or black water tanks) will not normally have high KH and will react greater.

    In the following passage we will try to explain how pH and KH are linked. As mentioned earlier the pH measurement is a ratio and how easy it is to change this ratio (pH stability) is dictated by the ionic (buffer) strength also known as KH. The images below illustrate how different ionic strengths can report the same pH value. If you imagine equal + hydrogen ions on one side of a balance to – hydrogen ions the other side then the level will flat or neutral. This would represent a pH of 7 and the absolute number of + or – ions on each side is not important so long as they balance.

      

    pH ratio and buffer - kH ions 100  to 100.pngpH ratio and buffer - kH ions 10  to 10 .pngpH ratio and buffer - kH ions 1 to 1.png

    If we were to mix the three different buffer strength waters shown above with and equal volume of water of a low pH (acidic) and weak buffer strength, say -5 ions & + 2 ions  we can see the effect below.

     

    pH ratio and buffer - kH ions 100  to 100 change.pngpH ratio and buffer - kH ions 10  to 10 change.pngpH ratio and buffer - kH ions 1 to 1 change.png

    As you can see the more highly buffered water doesn’t move much but the low buffered water moves huge amounts. Therefore the higher the buffering KH the more stable the pH. This is also why using RO water (which has no buffer strength) to lower pH will not work, it will however reduce the KH and pH stability.

    A low KH will also make and pH changes hard as pH will usually revert back to where it was; the ability to resist pH change is often called alkalinity. Eventually a low KH will also often lead to pH crashes.

    If you do need to adjust pH up or down we recommend always using both acid and base buffers; always make changes over a log period.  

    In the fresh water aquarium is plants which use CO2 present in the water throughout the day during a process called photosynthesis. CO2 is a gas dissolved in the aquarium water and that makes it more acidic (like fizzy drinks), when plants have no light CO2 starts to build up and lower pH.

    Why doesn’t my seneye match my digital probe or test kit? Click here to learn more...