Version as of 14:22, 20 Sep 2020

    to this version.

    Return to Version archive.

    View current version

    You can adjust the output for each parameter on a seneye device using a feature called Trim. This allows you to make ajustments to the device if you want the readings to match other test equipment you are using. To make a change please follow the instructions below:

     

    1. Open the SCA

    SCA_Trim_Stage_01.png

    If you cannot see the SCA, it may be in the system tray on your PC. Click here to find out how to check.

    2. Click on the settings tile

    SCA_Trim_Stage_02.png

    3. The output for each parameter is controlled by a slider

    SCA_Trim_Stage_03.png

    4. Adjust the output and click on the "Ok" button to save the change

    SCA_Trim_Stage_04.png

     

    The output then needs to sync with the servers so please allow a few minutes after the change has been made to show on your seneye connect and seneye.me dashboard.

     

    Turning off warning lights

    You can also turn off warning lights on the front of the device by clicking on them on the image of the right hand side of the seneye device. This will make the lights on the front of the device remain off even if one of the parameters goes out of range.