Version as of 11:31, 28 Mar 2024

    to this version.

    Return to Version archive.

    View current version

    seneye connect version 2 instructions

    If you have a seneye web server (sws) then please click here, as you are currently in the wrong place.

    Disconnect your seneye device (SUD) from the computer before completing ANY of the instructions below! 

     

    1. If you have not done so, please download the installer from the link below.

     

     

     

    2. Run the seneye connect installer

     

    You may be asked several questions throughout the installation process. Please click 'Yes', 'Repair', 'Agree' or 'Install' to proceed with the installation (a couple of examples of what you may see is shown below).

     

    SCA2_stage_01.png

     

    SCA2_stage_02.png

    Your seneye connect software will automatically launch when the installation is complete

     

    3. Log into the seneye connect software

     

    You will be prompted to log into the seneye.me account when the software runs. This is the same E-mail address and password that you used when you first registered with seneye.me. If you do not know your password please E-mail [email protected] and we will reset it for you.

     

    SCA2_stage_03.png

     

    Once logged in you will see the welcome screen as shown below: Please Do Not do anything without reading the instructions that follow.

     

    SCA2_stage_04.png

     

    4. Update the firmware in your seneye device

    If your device needs updating the SCA will update the firmware.

    It is a VERY important stage of the process and can damage your seneye device beyond repair if not done correctly. 

     

    Please connect your seneye device directly into one of the USB ports to the computer

     

    The seneye connect will talk you through each stage of updating your device on screen. The seneye device requires disconnecting and re-connecting from your computer to update the firmware. At each stage you will be prompted to do so by the seneye connect. 

    SCA2_stage_05.png

    DO NOT disconnect or re-connect the device if you are not prompted to do so.

     

    SCA2_stage_06.png

     

    When the firmware is updated, all four lights on the seneye connect will start to flash. Your firmware update is then complete.

    If you see the message "This SUD is not working as expected" please do not panic. This is usually caused by one of the following.

    • The internal calibration settings in the device syncing with the servers
    • Your account settings and alert lines syncing with the device
    • The time being set correctly inside the device

    If this does not clear after half an hour please contact [email protected].

    Next steps:

    Please refer to the following pages for how to use you seneye connect and seneye device

    Registering your slide

    Using the SCA

    Using the your device