Table of contents

    Version as of 00:20, 24 Jun 2021

    to this version.

    Return to Version archive.

    View current version

    Occasionally, when using Windows 7, 8 and 8.1 the seneye can apear in the controll may fail to install or not allow connection to the seneye device.

    This is normally cured by installing either the 32 or 64 bit version of the Belkin control center software. This are located on the install CD in the following directory - this is different to when the CD autoruns.


    You can then pick either setup32 or setup64.

    Please try each of them to see if it corrects the problem.

    You can also try the following software from a company called Silex.

    If you still have difficulty, please contact us on [email protected] for more advice.