Recovering your SWS from bootload mode

You SWS is designed to fail save in the event of a failure to update the firmware correctly. Whilst this is a very rare occurrence, it is designed to do this so the device can be easily recovered. 

If your device is in boot-load mode then the lights will be flashing in the sequence:

To recover your device from this state, please follow the instructions below:

Remove the seneye device from your SWS

Format a USB memory stick (ideally 16GB or maller) to "FAT32"

Download the SWS firmware from here

Copy the firmware onto the memory stick

Insert the stick into the USB socket on the SWS

The light sequence will then change whilst the firmware is loading

When the firmware is loaded the power light will remain on constantly

Reconnect any cables that you have disconnected